max6675

Libraries for STM32 (STM32F103C8T6) on pure CMSIS.

MAX6675 full-featured driver library for general-purpose MCU and Linux.

Library for MAX6675/MAX31855 from Maxim Integrated for STM32

A feature-rich reflow Hot-Plate firmware i.e. usable for "Tim's Hot Plate" (https://www.instructables.com/Tims-Hot-Plate/)

Arduino library for MAX6675 chip for K type thermocouple

[For Arduino] Library for working with a thermocouple based on the MAX6675 driver.

Arduino library for 12-bit MAX6675 K-thermocouple to digital converter

This project features an engine control unit (ECU) for a gas turbine, built on the ESP32 platform. The code is developed using the Arduino IDE and leverages readily available libraries for ease of integration and development. The repository also includes optional code for a turbine engine instrument cluster, designed to run on a separate ESP32.

Drum coffe Roaster: Arduino, Temp PID control, SSR Electric heat sistem,

An Handheld Thermocouple thermometer based on Digistump

ESP32 Peripheral Drivers built with ESP-IDF

A ESP32 based Temperture monitor and timer with ST7789 TFT Display.

PID temperature controller for laboratory use

Cross-platform embedded C libraries for multiple microcontroller platforms

A variation of my PI controlled Temp / status monitors. This has DHT22 sensors, 2-wire sensors, Thermocouples, and MQTT control of a binary sensor/GPIO pin. Send data to a Home Assistant Instance via MQTT Discovery. Send a command from HA via MQTT and change a GPIO on the PI.

Arduino multichannel input module for MAX31855 and MAX6675 with serial interface

Max6675 Thermocople + Wemos d1 + Blynk

паяльник на ардуино (тысячи их)

Caracterización de termopar con MAX6675 en Arduino

Khadas VIM3 running SPI device MAX6675